2010 Cadillac Truck SRX FWD V6-3.0L Page 1549
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B393B 04
- Air Conditioning Compressor Valve Control Circuit Open
DTC B393B 0B
- Air Conditioning Compressor Valve Control Circuit High Current
Circuit/System Description
The HVAC control module supplies battery voltage to the A/C compressor. When the A/C switch is pressed, the HVAC control module provides a
pulse width modulation (PWM) signal to the A/C compressor in order to command the performance of the A/C compressor. The performance of the
A/C compressor is regulated according to adjusted interior temperature on the basis of characteristic lines. Therefore the HVAC control module
grounds the A/C compressor with the PWM signal.
Conditions for Running the DTC
* Ignition ON.
* The HVAC control module is ON.
Conditions for Setting the DTC
B393B 04
A PWM greater than 10% is send out but no current is read back.
B393B 0B
Measured current is above threshold of 815 mA.
Action Taken When the DTC Sets
B393B 04
The A/C compressor is disabled.
B393B 0B
* The A/C compressor is disabled.
* Output will be switched off for hardware protection.
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
HVAC Schematics (See: Heating and Air Conditioning/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Automatic HVAC Description and Operation (See: Heating and Air Conditioning/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
No comments:
Post a Comment