Showing posts with label Body - Rear Hatch Rattling. Show all posts
Showing posts with label Body - Rear Hatch Rattling. Show all posts

Wednesday, November 21, 2018

Body - Rear Hatch Rattling


Body - Rear Hatch Rattling



SI M 41 01 02



Body



March, 2002-2006



Technical Service



This Service information bulletin supersedes Advance S.I. M41 01 02 dated February, 2002-2006.



[NEW]Designates changes to this revision.



SUBJECT



Rattles from Rear Hatch



MODEL



Cooper, Cooper S production date prior to 12/03



2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 135



SITUATION



Some owners may experience rattles from the rear hatch when driving over rough surfaces.



These rattles can be caused by the fit of the striker in the rotary latch or by play in the stop buffers.



CORRECTION



[NEW]Several improvements have been made to the latching system and stop buffers to eliminate play that may cause rattles. These improvements



were phased into production from 2/03 through 11/03.



[NEW]PARTS INFORMATION



[NEW]PROCEDURE



In case of a customer complaint, check the striker to see if it is painted gray or chrome plated. Any gray painted or chrome plated strikers should be



replaced with the black painted strikers, part number 51 24 7 154 735, per Repair Instructions, section 51 24 130. Depending on the production date



of the car, the following repairs should also be performed.



Cars produced prior to 2/03:



A. Install soft buffers, part number 51 24 0 305 688. Adjust so that distance "A" is 35 mm.&line; The later parts can be distinguished from



the early style by the size of the hole in the base of the buffer. The early parts had an approximately 7.5 mm diameter hole and the new



part has an approximately 5.5 mm diameter hole.



Cars produced prior to 4/03:



Perform step (A) above



2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 136



B. Install new mounting screws for latch (1), part number 07 14 0 303 020, and adjust latch (2) per Repair Instructions, section 51 24 004.



Cars produced prior to 7/03:



Perform steps (A+B) above



C. Check to see if the additional buffers (2) are installed on the upper bumper cover mounting tabs (1). If they are not present, remove the



Phillips head screw and washer and install additional buffers.



Assembly of the additional buffer is as illustrated:



Push insert (1) and screw (2) into base of buffer (3) and install into existing hole in bumper cover tab.&line;&line;Insert - part numbers



51 24 7 141 880.



Screw - part number 07 14 7 142 053



Buffer - part number 51 24 7 141 879



[NEW]WARRANTY INFORMATION



2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 137



Covered under the terms of the New Vehicle Limited Warranty. Choose the appropriate operation from the list shown.



2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 138