Showing posts with label Campaign - Update Front SAM Parameters FILE: SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER. Show all posts
Showing posts with label Campaign - Update Front SAM Parameters FILE: SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER. Show all posts

Friday, April 6, 2018

Technical Service Bulletin # 2010030010 Date: 100401

Mercedes-Benz Mercedes Benz OEM Parts Mercedes Benz OE Replacement Parts Mercedes Benz E 550 4MATIC Sedan Technical Service Bulletin # 2010030010 Date: 100401
Campaign - Update Front SAM Parameters
FILE:
SERVICE: GROUP 00 OF SERVICE INFORMATION BINDER
PARTS: GROUP I OF INFORMATION _ PARTS & ACCESSORIES BINDER
Campaign No. 2010030010, April 2010
TO: ALL MERCEDES-BENZ CENTERS
SUBJECT: Model 212, Model Year 2010
Update Front SAM Parameters
This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the
specified values of the backup battery in the front SAM may be set too low. This may lead to fault messages in the instrument cluster. Dealers will
update the front SAM parameters at the next workshop visit.
Prior to performing this Service Campaign:
^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.
^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.
Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.
Approximately 16,616 vehicles are affected.
Procedure
2010 Mercedes Benz E 550 4MATIC Sedan (212.090) V8-5.5L (273.970)   Page 373
Note:
^ Use Xentry 01-02/2010 with all associated patches or higher.
^ Follow the steps exactly as described in Xentry.
^ Battery charger not required.
1. Connect Star Diagnosis to vehicle.
2. Update backup battery coding: Control unit view/Driver-side SAM - Front signal acquisition and actuation module
(N10/1)/Adaptations/Configuration/SCN/SCN coding.
3. Follow on-screen instructions.
Note:
The following allowable labor operation should be used when submitting a warranty claim for this repair:
Warranty Information