Monday, May 16, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 2075

2010 Cadillac Truck SRX FWD V6-3.0L Page 2075



Inspection/Programming and Relearning). If the DTC resets, replace the K20 ECM.



3. Observe the DTC information with a scan tool. Verify that DTC P0601, P0603, P0604, P0606, P062B, P062F, P16F3, or P2610 does not set.



瀚慖f a DTC failed this ignition, replace the K20 ECM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P2635



DTC P2635 (Fuel Pump Control Module)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC P2635



- Fuel Pump Flow Performance



Diagnostic Fault Information



Circuit/System Description



The engine control module (ECM) supplies voltage to the fuel pump control module when the ECM detects that the ignition is on. The voltage from



the ECM to the fuel pump control module remains active for 2 seconds, unless the engine is in crank or run. While this voltage is being received,



the fuel pump control module closes the ground switch of the fuel pump and also supplies a varying voltage to the fuel tank pump module in order



to maintain the desired fuel rail pressure.



Conditions for Running the DTC



* DTC P018B, P018C, P018D, P0231, P0232, P023F, P064A, P1255 or P06A6 are not active.



* DTC P0641 has not failed this ignition cycle.



* Fuel pump control is enabled and the fuel pump control state is normal.



* The system voltage is greater than 11 V.



* The engine has been running for more than 30 seconds.



Conditions for Setting the DTC



This DTC sets when the fuel pump control module detects a predetermined fuel pressure performance degradation between the desired fuel rail



pressure and the current estimated fuel rail pressure.



Action Taken When the DTC Sets



DTC P2635 is a Type B DTC.



Conditions for Clearing the DTC



DTC P2635 is a Type B DTC.



Diagnostic Aids



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records

No comments:

Post a Comment