2010 Cadillac Truck SRX FWD V6-3.0L Page 1593

2010 Cadillac Truck SRX FWD V6-3.0L Page 1593

Conditions for Setting the DTC

P0601

The read only memory (ROM) test has failed 5 or more times.

P0602

The TCM has been unable to detected the start program.

P0603

The TCM has detected a memory checksum error.

P0604

The TCM random access memory (RAM) test has failed 5 or more times.

Action Taken When the DTC Sets

P0601, P0602, P0603, P0604

* DTCs P0601, P0603, P0604 are Type A DTCs.

* The TCM commands maximum line pressure.

* The TCM forces the torque converter clutch (TCC) OFF.

* The TCM inhibits TCC engagement.

* The TCM freezes transmission adaptive functions.

* The TCM commands an immediate landing to 2nd gear.

Conditions for Clearing the DTC

DTCs P0601, P0602, P0603, P0604 are Type A DTCs.

Reference Information

Description and Operation

Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine running. Let the engine run for at least 1 min.

2. Ignition OFF for at least 30 s to allow for the complete shutdown of the TCM.

3. Ignition ON, verify that DTC P0602 is not set.

瀚慖f the DTC is set, program the TCM. If the DTC resets, replace the TCM.

4. Observe the DTC information with a scan tool. DTCs P0601, P0603, P0604 should not set.

瀚慖f a DTC sets, replace the TCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for TCM replacement, setup, and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).