Sunday, November 21, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 1909

2010 Cadillac Truck SRX FWD V6-3.0L Page 1909



P1761



DTC P1761



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P1761



- Up and Down Shift Switch Signal Circuit



Circuit/System Description



A signal circuit is provided by the body control module (BCM) to the resistor network embedded in the plus or minus buttons. When a plus or



minus button is pressed, a corresponding voltage drop occurs across the resistor network. This voltage drop is monitored by the BCM. The BCM



will send the request to the transmission control module (TCM) to perform the upshift or downshift. The TCM is constantly monitoring the serial



data sent from the BCM for the correct number and sequence of counts for Tap Up and Tap Down function.



Conditions for Running the DTC



* The TCM rolling counter diagnostic is enabled.



* The Tap Up and Tap Down health message health is received from the BCM.



* The ignition voltage is 8.6 volts or greater.



* The engine speed is 500 RPM or greater for at least 5 seconds.



Conditions for Setting the DTC



The TCM detects an error in the rolling count value that does not match with the BCM count, within 10 seconds.



Action Taken When the DTC Sets



* DTC P1761 is a Type C DTC.



* The TCM disables TAP Shift operation.



Conditions for Clearing the DTC



DTC P1761 is a Type C DTC.



Reference Information



Schematic Reference



* Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)



* Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical



Diagrams)



* Body Control System Schematics (See: Body and Frame/Body Control Systems/Diagrams/Electrical Diagrams)



Connector End View Reference



* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/6T70/6T75 -



Automatic Transmission/Electronic Component Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)

No comments:

Post a Comment