Tuesday, May 18, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 603

2010 Cadillac Truck SRX FWD V6-3.0L Page 603



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Clear all DTCs and operate the steering column lock control module within the conditions for running the DTC. The DTC should not set.



If the DTC sets, reprogram the K60 Steering Column Lock Control Module. If the DTC resets, replace the K60 Steering Column Lock Control



Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Steering Column Lock Control Module Replacement (ULS) (See: Steering and Suspension/Steering/Steering Column/Steering Column



Lock/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for steering column lock control module



replacement, setup and programming



B2955



DTC B2955



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B2955 00



- Security Sensor Data Circuit



Diagnostic Fault Information



Circuit/System Description



When an ignition key is inserted into the ignition lock cylinder and the ignition is switched ON, the transponder embedded in the key is energized



by the exciter coils surrounding the ignition lock cylinder. The transponder transmits a signal to the body control module (BCM). The BCM then



compares this value to a value stored in memory. If the value is correct, the BCM will send the prerelease password via the serial data circuit to the



engine control module (ECM). If the learned key code does not match or a transponder value is not received, the BCM will send the start disable



password to the ECM.



Conditions for Running the DTC



Ignition is in the Accessory or Run position.



Conditions for Setting the DTC



The BCM detects a circuit fault between itself and the immobilizer control module.



Action Taken When the DTC Sets



* Vehicle starting will be disabled.



* The security indicator in the instrument cluster will be illuminated. A service message will be displayed in the driver information center.



Conditions for Clearing the DTC



* A current DTC will be cleared when the condition for setting the DTC are no longer present.

No comments:

Post a Comment