Monday, May 31, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 359

2010 Cadillac Truck SRX FWD V6-3.0L Page 359



The liftgate motor is a bi-directional motor and open or close operation is the result of the direction of the motor rotation. The liftgate control



module controls the liftgate motor through the control circuits by supplying power and ground in the appropriate polarity. The motor control



circuits are monitored by the liftgate control module prior to activation for a high or low condition and during motor operation for any irregular



current flow conditions.



Conditions for Running the DTC



* The system voltage is 9-16 V.



* Power open or close function is initiated.



Conditions for Setting the DTC



B396A 01



The liftgate control module detects a short to voltage in a liftgate motor control circuit.



B396A 02



The liftgate control module detects a short to ground in a liftgate motor control circuit.



B396A 04



The liftgate control module detects an open/high resistance in a liftgate motor control circuit or the liftgate control module B+ circuit. A short to



ground in the liftgate control module B+ circuit.



Action Taken When the DTC Sets



The power liftgate may be inoperative in the power mode and in the manual mode.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Diagnostic Aids



* If the liftgate will not release from the closed position, refer to Opening the Liftgate Without Electrical Power (See: Body and Frame/Doors,



Hood and Trunk/Trunk / Liftgate/Service and Repair/Procedures) for the appropriate procedure



* Whenever the liftgate control module loses power or is disconnected, the ignition must be cycled OFF then ON in order to reactivate the



liftgate control module.



* DTC B396A 01 may set as current or history when the liftgate control module detects erratic voltage levels in the electrical system and does



not affect the operation of the power liftgate. If this DTC is set and the liftgate functions normally, clear the DTC



Reference Information



Schematic Reference



Liftgate Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Liftgate Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Liftgate Description and Operation (See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Description and Operation/Liftgate)



Electrical Information Reference



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

No comments:

Post a Comment