Friday, May 21, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 728

2010 Cadillac Truck SRX FWD V6-3.0L Page 728



Schematic Reference



Trailer Connector/Provision Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System



Diagram/Trailer Connector/Provision Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the function of the trailer stop lamps while commanding the Trailer Stop Lamp ON and OFF with a scan tool. The trailer stop



lamps should turn ON and OFF while changing between the commanded states.



Circuit/System Testing



1. Ignition OFF, disconnect the X1 harness connector at the K68 trailer lighting control module.



2. Test for infinite resistance between the control circuit terminal 10 and ground.



瀚慖f less than the specified value, test the control circuit for a short to ground. If the circuit tests normal, replace the X88 trailer connector.



3. Test for less than 1 ohm between the control circuit terminal 10 at the K68 trailer lighting control module and control circuit terminal 6 at the



X88 trailer connector.



瀚慖f greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal,



replace the X88 trailer connector.



4. If all the circuits test normal, replace the K68 trailer lighting control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for trailer brake control module replacement,



programming and setup



B3891



DTC B3891



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3891 02



- Trailer Fog Lamps Circuit Short to Ground

No comments:

Post a Comment