Sunday, May 2, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 679

2010 Cadillac CTS Sedan AWD V6-3.6L Page 679



C0010 03



* Ignition ON.



* System and ignition voltage is above 9 volts.



* The system enable relay is ON.



C0010 04



* Ignition ON.



* System and ignition voltage is above 9 volts.



* The system enable relay is ON.



* The pump motor has been commanded OFF for 2 seconds.



C0010 61



* Ignition ON.



* The system enable relay is ON.



* The pump motor has been commanded ON, OFF and ON again.



Conditions for Setting the DTC



C0110 03



The EBCM detects an open in the pump motor driver or supply when the motor is commanded on and if the motor feedback is below 50% of the



system voltage for 10 msec.



C0110 04



The EBCM detects an open in the pump motor circuit when the feedback voltage remains greater than 0.75 volt for more than 50 msec.



C0110 61



The pump motor continues to rotate briefly after activation creating a feedback voltage. The EBCM sets the code if the measured feedback voltage



indicates an open circuit, binding or stalled pump motor.



Actions Taken when the DTC Sets



* The EBCM disables the antilock brake system (ABS), traction control system and StabiliTrak for the duration of the ignition cycle.



* A driver information center message and/or a warning indicator may be displayed.



Conditions for Clearing the DTC



* The condition for the DTC is no longer present.



* Operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test, and the EBCM will turn off the ABS indicator.



* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.



Reference Information



Schematic Reference



Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the EBCM.



2. Test for less than 5 ohm between the ground circuits listed below and ground.

No comments:

Post a Comment