2010 Cadillac CTS Sedan AWD V6-3.6L Page 220

2010 Cadillac CTS Sedan AWD V6-3.6L Page 220



Circuit/System Description



The interior liftgate control switch contains 3 resistors which are in series for the liftgate mode, depending upon which position is selected will



determine which combination of resistors are used. The liftgate module monitors the voltage level in the liftgate mode signal circuit, as each mode



is selected, the voltage within the signal circuit incrementally drops. It is this method the the liftgate module will determine the if mode switch is in



the manual mode, the garage mode or the maximum open mode.



Conditions for Running the DTC



The system voltage is 9-16 volts.



Conditions for Setting the DTC



The liftgate control module detects an out of range condition in the mode switch signal circuit.



Action Taken When the DTC Sets



The liftgate will be inoperative in the power and manual modes.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Diagnostic Aids



Note: Before testing can be performed, the liftgate must be opened. Refer to Opening the Liftgate Without Electrical Power (See: Body and



Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Procedures) for the appropriate procedure.



Whenever the LGM loses power or is disconnected, the ignition must be cycled OFF then ON in order to reactivate the LGM.



In some circumstances high or low control circuit faults may cause the LGM to react as if the liftgate has encountered an object in its travel and



reverse direction.



Reference Information



Schematic Reference



Liftgate Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Liftgate Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

The BMW M5 Sedan & M5 Touring with BMW M Performance Parts.