Tuesday, May 18, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 676

2010 Cadillac CTS Sedan AWD V6-3.6L Page 676



Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming



Park Brake



DTC C056E



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provide an overview of each diagnostic category.



DTC Descriptors



DTC C056E 41



- Electronic Control Unit Software Not Programmed



DTC C056E 42



- Electronic Control Unit Software Calibration Not Programmed



DTC C056E 5A



- Electronic Control Unit Software Not Plausible



Circuit/System Description



The electric parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electric parking brake



control module also contains the logic for applying and releasing the parking brake when commanded by the electric parking brake switch. When



the electric parking brake control module receives a signal from the switch the internal circuit board temperature is checked to verify it is within



operating range before the control module performs the requested operation.



Conditions for Running the DTC



Ignition OFF, ACCESSORY, or RUN mode.



Conditions for Setting the DTC



The electric parking brake module has detected an internal software malfunction.



Actions Taken When DTC Sets



C056E 41, C056E 5A



* The electric parking brake is disabled.



* A message and/or a warning indicator may be displayed.



C056E 42



* The electric parking brake functionality is degraded.



* A message and/or a warning indicator may be displayed.



Conditions for Clearing the DTC



* The electric parking brake module clears the history DTC when a current DTC is not detected in 40 ignition cycles.



* The condition for the DTC is no longer present.



* The latest software and calibrations are programmed into the electric parking brake module.



Reference Information



Schematic Reference



Park Brake System Schematics (See: Brakes and Traction Control/Parking Brake System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Electronic Parking Brake Control Module Description (See: Brakes and Traction Control/Parking Brake System/Parking Brake Control



Module/Description and Operation)

No comments:

Post a Comment