Friday, May 7, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 290

2010 Cadillac CTS Sedan AWD V6-3.6L Page 290



SIR Schematics (See: Diagrams/Electrical Diagrams/Air Bag Systems)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



SIR System Description and Operation (See: Restraints and Safety Systems/Air Bag Systems/Description and Operation/SIR System Description



and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



B1019 3A



1. With a scan tool, verify DTC B1370 is not set as current in the SDM.



瀚慖f DTC is current refer to DTC B1370 (See: B Code Charts/B1370).



2. If equipped with PPS, verify the appropriate PPS indicator segments illuminate by occupying and un-occupying the passenger seat.



瀚慖f the PPS indicator segments do not illuminate properly, replace the PPS indicator.



Circuit/System Testing



Important: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or



replacement of the affected.



* The PPS module



* SDM



* The PPS module wiring harness connector



* SDM wiring harness connector



B1019 00



1. Ignition ON, verify the scan tool End Model Part Number is correct for the vehicle.



瀚慖f the part number is incorrect, reprogram the SDM.



Important:



* If not equipped with PPS, the scan tool parameter should display Not Present and the PPS indicator should not be present on the



vehicle



* If equipped with PPS, the scan tool parameter should display Auto, Manual, or Auto + Man and the PPS indicator should be



present on the vehicle



2. Observe the scan tool PPS Options parameter to determine how the vehicle PPS is currently configured in the SDM. Verify the actual vehicle



equipment and the current configuration indicated by the scan tool parameter are the same.



瀚慖f the original configuration does not match the actual vehicle equipment, reprogram the SDM with the correct configuration.



3. Ignition OFF, disconnect the harness connectors at the SDM and verify the connector is in good condition and has no bent pins, terminals or



shorting bars



瀚慖f damage is found, repair the bent pins, terminals or shorting bars as needed and perform the Setup New SDM procedure.



4. Connect the harness connector at the SDM.



5. Ignition ON, verify the scan tool System Configuration matches the actual components installed on the vehicle.

No comments:

Post a Comment