Thursday, April 29, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 541

2010 Cadillac CTS Sedan AWD V6-3.6L Page 541



Conditions for Clearing the DTC



* A current DTC will clear when the condition for setting the DTC is no longer present.



* A history DTC will clear after 40 malfunction-free ignition cycles.



Reference Information



Schematic Reference



Shift Lock Control Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shift Interlock/Diagrams/Electrical



Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Automatic Transmission Shift Lock Control Description and Operation (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Shift Interlock/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool RCDLR Authentication Switch parameter. The parameter should be Active only when the ignition switch knob



is pressed.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the ignition switch.



2. Verify the scan tool Authentication Switch parameter is Inactive.



瀚慖f not the specified value, test the signal circuit terminal 5 for a short to voltage. If the circuit tests normal, replace the RCDLR.



3. Install a 3A fused jumper wire between the signal circuit terminal 5 and B+. Verify the scan tool Authentication Switch parameter is Active.



瀚慖f not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the



RCDLR.



4. If all circuits tests normal, test or replace the ignition switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition



Switch/Service and Repair/Ignition and Start Switch Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for RCDLR replacement, setup, and programming



B2996



DTC B2996 or B3001



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment