2010 Cadillac CTS Sedan AWD V6-3.6L Page 634

2010 Cadillac CTS Sedan AWD V6-3.6L Page 634

High speed wiper operation is suspended.

Conditions for Clearing the DTC

* A current DTC will clear when the condition for setting the fault is no longer seen.

* A history DTC will clear after 50 consecutive ignition cycles without a fault present.

Reference Information

Schematic Reference

Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Wiper/Washer System Description and Operation (Wiper and Washers) (See: Wiper and Washer Systems/Description and

Operation/Wiper/Washer System Description and Operation (Wiper and Washers))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the WPR HI relay.

2. Connect a test lamp between the control circuit terminal 86 and B+.

3. Ignition ON, command the high speed wipers ON and OFF using the wiper switch. The test lamp should turn ON and OFF when changing

between the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the BCM.

4. If all circuits test normal, test or replace the WPR HI relay.

Component Testing

1. Ignition OFF, disconnect the WPR HI relay.

2. Test for 60-200 ohms between terminals 85 and 86.

瀚慖f the resistance is not within the specified range, replace the relay.

3. Test for infinite resistance between the following terminals:

* 30 and 86

* 30 and 87

* 30 and 85

* 85 and 87

瀚慖f not the specified value, replace the relay.

4. Test for less than 2 ohms between terminals 30 and 87A.

瀚慖f greater than the specified range, replace the relay.

5. Install a 10A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for

less than 2 ohms between terminals 30 and 87.

瀚慖f greater than the specified range, replace the relay.