Monday, April 19, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 566

2010 Cadillac CTS Sedan AWD V6-3.6L Page 566



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the rear compartment keyless entry antenna.



2. Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal A and ground.



瀚慖f the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the RCDLR.



3. Install a DMM between the signal circuit terminal A and the low reference circuit terminal B. Set the DMM to capture AC voltage using the



MIN MAX function.



4. Press the rear compartment lid release switch. Verify the DMM captured an AC voltage signal.



瀚慖f an AC voltage was not captured, test the signal circuit and the low reference circuit for a short to ground or an open/high resistance. If



the circuits test normal, replace the RCDLR.



5. If all circuits test normal, test or replace the rear compartment keyless entry antenna.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for RCDLR replacement, setup, and programming



B3122



DTC B3122



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B3122 00



- Keyless Entry Antenna 4 Performance - Console Active Antenna



Diagnostic Fault Information



Circuit/System Description



The console active antenna is located in the center console and is used to establish low frequency (LF) communications with the keyless entry



transmitter The keyless entry console active antenna is only used when the console passive antenna was unable to locate a transmitter within the

No comments:

Post a Comment