2010 Cadillac CTS Sedan AWD V6-3.6L Page 538

2010 Cadillac CTS Sedan AWD V6-3.6L Page 538

* A current DTC will clear when the soft stops have been learned.

* A history DTC will clear after 100 ignition cycles.

Reference Information

Schematic Reference

Tilt/Telescoping Steering Column Schematics (See: Diagrams/Electrical Diagrams/Steering/Steering Column/Tilt/Telescoping Steering Column

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Steering Wheel and Column Description and Operation (See: Steering and Suspension/Steering/Steering Column/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition ON, perform the scan tool Learn Column Soft Stops procedure. Refer to Telescoping Steering Column Calibration (See: Steering

and Suspension/Steering/Steering Column/Testing and Inspection/Programming and Relearning).

2. Operate the vehicle within the Conditions for Running and Setting. Verify DTC B2890 does not reset.

瀚慖f the DTC resets, replace the MSM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming

B2924

DTC B2924

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2924 00

- Content Theft System Sensor 3 Signal Circuit

Diagnostic Fault Information

Circuit/System Description