2010 Cadillac CTS Sedan AWD V6-3.6L Page 277

2010 Cadillac CTS Sedan AWD V6-3.6L Page 277

DTC B1008 00

- Calibration Data Not Programmed

Circuit/System Description

When replacing a remote control door lock receiver (RCDLR), the service replacement part is shipped with no installed software. Before the new

RCDLR is operational, a software calibration is required to be downloaded using the SPS terminal. Failure to download this software calibration

will result in the setting of DTC B1008.

Conditions for Running the DTC

This DTC runs continuously

Conditions for Setting the DTC

The RCDLR has no calibration loaded.

Action Taken When the DTC Sets

All functions handled by the RCDLR are inoperative

Conditions for Clearing the DTC

A current DTC will clear when software calibrations are installed.

Reference Information

Schematic Reference

Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry

Transmitter/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Keyless Entry System Description and Operation (with RPO Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm

Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (with RPO Y41))Keyless Entry System

Description and Operation (without RPO Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless

Entry/Description and Operation/Keyless Entry System Description and Operation (without RPO Y41))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Perform the RCDLR Programming and Setup procedure. Refer to Remote Control Door Lock Receiver Programming and Setup (without RPO

Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Receiver/Testing and

Inspection/Remote Control Door Lock Receiver Programming and Setup (without RPO Y41))Remote Control Door Lock Receiver Programming

and Setup (with RPO Y41 - Canada and Europe) (See: Application and ID)Remote Control Door Lock Receiver Programming and Setup (with

RPO Y41 - North America and Asia) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry

Receiver/Testing and Inspection/Remote Control Door Lock Receiver Programming and Setup (with RPO Y41 - North America and Asia)).

If the DTC resets, replace the RCDLR.

Repair Instructions

Important: This vehicle may be equipped with the 2 Way Advanced Remote Start System. Vehicle equipped with the 2 Way Advanced

Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing

the 2 Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2 Way

Advanced Remote Start System can be found in the Accessory section of the parts manual.