2010 Cadillac CTS Sedan AWD V6-3.6L Page 291

2010 Cadillac CTS Sedan AWD V6-3.6L Page 291

瀚慖f the System Configuration does not match the actual components installed, reprogram the SDM with the correct components.

6. Ignition ON, clear all PPS and SDM DTCs.

7. Verify DTC B1019 does not set.

瀚慖f DTC sets, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/SIR/SRS Wiring Repairs)

* Radio Control Assembly Replacement (with Navigation Display) (See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Radio Control Assembly Replacement (with Navigation Display))Radio Control Assembly

Replacement (without Navigation Display) (See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Radio Control Assembly Replacement (without Navigation Display))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM or BCM replacement, setup, and

programming

Vehicle Access

DTC B1019

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC B1019 00

- System Configuration Error

Circuit/System Description

When calibrating the liftgate position, the liftgate module (LGM) is placed in a functional state to learn the liftgate travel limits. DTC B1019 00

will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the travel limits are learned by the LGM, the

liftgate module will exit calibration mode and DTC B1019 00 become a history code.

Conditions for Running the DTC

The system voltage is 9-18 V.

Conditions for Setting the DTC

Whenever the LGM is replaced or in learn mode.

Action Taken When the DTC Sets

The power liftgate system will be disabled.

Conditions for Clearing the DTC

* The DTC will be current until the liftgate calibration procedure has been completed.

* When the calibration procedure has been completed the DTC will be a history DTC.

Diagnostic Aids

Setting B1019 00 is normal after flashing the liftgate module. This DTC will be current after flashing and the DTC will go to history after learning.

This is a normal behavior by design and is not necessary to replace the liftgate module.