2010 Cadillac CTS Sedan AWD V6-3.6L Page 576

2010 Cadillac CTS Sedan AWD V6-3.6L Page 576



Conditions for Running the DTC



Battery voltage is between 9-16 volts.



Conditions for Setting the DTC



The BCM detects a fault in the trunk release relay control circuit.



Action Taken When the DTC Sets



The rear compartment latch will not operate.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles



Reference Information



Schematic Reference



Release Systems Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Release Systems Schematics)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Luggage Compartment Description and Operation (See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, command the trunk release with a scan tool. The rear compartment lid latch should release the trunk lid.



Circuit/System Testing



1. Ignition OFF, disconnect the TRUNK/RELSE relay.



2. Test for less than 5 ohms between the ground circuit terminal 85 and ground.



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



3. Connect a test lamp between the control circuit terminal 86 and the ground circuit terminal 85.



4. Ignition ON, command the trunk release ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the



commanded states.



瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.



瀚慖f the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the BCM.



5. If all circuits test normal, test or replace the TRUNK/RELSE relay.



Component Testing



Relay Test



1. Ignition OFF, disconnect the TRUNK/RELSE relay.



2. Test for 60-180 ohms between terminals 85 and 86.



瀚慖f not within the specified range, replace the relay.

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

The BMW M5 Sedan & M5 Touring with BMW M Performance Parts.