2010 Cadillac CTS Sedan AWD V6-3.6L Page 775

2010 Cadillac CTS Sedan AWD V6-3.6L Page 775



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.



Circuit/System Verification



1. Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 V



瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests



and General Diagnostics/Charging System Test)



2. Engine running, observe the scan tool EBCM Battery Voltage Signal parameter. The reading should be between 12.6 and 15.5 V



瀚慖f not within the specified range, replace the EBCM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup and programming.



C1100



DTC C1100



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC C1100 00



- Vacuum Sensor Out of Range



DTC C1100 01



- Vacuum Sensor Short to Voltage



DTC C1100 06



- Vacuum Sensor Short to Ground



DTC C1100 5A



- Vacuum Sensor Not Plausible



Diagnostic Fault Information



Circuit/System Description



The brake booster vacuum sensor measures the vacuum in the brake booster assembly. The electronic brake control module (EBCM) supplies a 5 V



reference and a low reference circuit to the brake booster vacuum sensor. The vacuum sensor supplies a voltage signal in relation to the pressure in



the brake booster to the EBCM.

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

The BMW M5 Sedan & M5 Touring with BMW M Performance Parts.