2010 Cadillac CTS Sedan AWD V6-3.6L Page 622

2010 Cadillac CTS Sedan AWD V6-3.6L Page 622



The body control module (BCM) monitors the window UP/DOWN command from the driver door module (DDM). When the rear window UP or



DOWN command is received, the BCM sends a signal to the appropriate rear window switch. The rear window switches continuously monitor the



up and down signal circuits, if no function is being commanded, the signal voltage is at approximately B+ voltage. If the UP or DOWN function is



commanded, the BCM signal voltage drops approximately 5 volts and the appropriate rear window switch will then command the window in the



UP or DOWN direction.



Conditions for Running the DTC



Battery voltage is between 9-16 volts.



Conditions for Setting the DTC



B3819 00



The BCM detects a fault in the left rear window up circuit.



B3820 00



The BCM detects a fault in the left rear window down circuit.



B3822 00



The BCM detects a fault in the right rear window up circuit.



B3823 00



The BCM detects a fault in the right rear window down circuit.



Action Taken When the DTC Sets



The left or right rear power window will be inoperative from the driver master control.



Conditions for Clearing the DTC



* The DTC will be current for as long as the fault is present.



* When the fault is no longer present, the DTC will be a history DTC.



* A history DTC will clear after 50 ignition cycles.



Reference Information



Schematic Reference



Moveable Window Schematics (See: Windows and Glass/Windows/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Power Windows Description and Operation (See: Windows and Glass/Windows/Description and Operation/Power Windows Description and



Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, command the appropriate rear door window UP and DOWN by using the window switch on the driver master control. The rear door



window should perform UP and DOWN function.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.

Comments