2010 Cadillac CTS Sedan AWD V6-3.6L Page 82

2010 Cadillac CTS Sedan AWD V6-3.6L Page 82



* Stage 1 terminal 1



* Stage 2 terminal 3



瀚慖f not the specified value, test the control circuit for a short to ground.



13. Test for infinite resistance between the appropriate low control circuit terminal and ground.



* Stage 1 terminal 2



* Stage 2 terminal 4



瀚慖f not the specified value, test the control circuit for a short to ground.



14. Disconnect the harness connector at the SDM.



15. Test for less then 1 ohm between the following high control circuit terminals.



* Steering wheel module coil connector Stage 1 terminal 1 X3 and SDM terminal 9



* Steering wheel module coil connector Stage 2 terminal 3 X3 and SDM terminal 5



瀚慖f not within the specified range, test the control circuit for an open/high resistance.



16. Test for less then 1 ohm between the following low control circuit terminals.



* Steering wheel module coil connector Stage 1 terminal 2 X3 and SDM terminal 8



* Steering wheel module coil connector Stage 2 terminal 4 X3 and SDM terminal 4



瀚慖f not within the specified range, test the circuit for an open/high resistance.



17. If all circuits test normal, replace the SDM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Steering Wheel Inflatable Restraint Module Replacement (See: Restraints and Safety Systems/Air Bag Systems/Air Bag/Service and



Repair/Removal and Replacement/Steering Wheel Inflatable Restraint Module Replacement)



* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/SIR/SRS Wiring Repairs)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming



B0014



DTC B0014-B0045



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0014 01



- Driver Side Deployment Loop Short to Battery - Seat Air Bag



DTC B0014 02



- Driver Side Deployment Loop Short to Ground - Seat Air Bag



DTC B0014 04



- Driver Side Deployment Loop Open Circuit - Seat Air Bag



DTC B0014 0D



- Driver Side Deployment Loop Resistance Above Threshold - Seat Air Bag



DTC B0014 0E



- Driver Side Deployment Loop Resistance Below Threshold - Seat Air Bag

Comments