2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2269

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2269

the transmission case.

瀚慖f not within the specified range, replace the control solenoid valve assembly.

4. Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6L45/6L50/6L80/6L90 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Input

Shaft Speed/Output Shaft Speed Input Test).

5. Inspect the machined slots on the output shaft housing outer surface for damage or misalignment. Repair or replace as necessary.

6. If all of the above test normal, replace the B14A/B14C ISS/OSS assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Perform the Input and Output Speed Sensor Replacement (See: Powertrain Management/Transmission Control Systems/Sensors and

Switches - Transmission and Drivetrain/Sensors and Switches - A/T/Transmission Speed Sensor/Service and Repair/6L45/6L50/6L80/6L90 -

Automatic Transmission).

* Control solenoid valve assembly - refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for

replacement, setup, and programming.

* Perform the Control Solenoid Valve and Transmission Control Module Assembly Input Shaft Speed/Output Shaft Speed Input Test (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6L45/6L50/6L80/6L90 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Input

Shaft Speed/Output Shaft Speed Input Test).

* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Programming and Relearning) following all transmission related repairs.

6L50/6L80/6L90 - Automatic Transmission

DTC P0722 or P0723

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0722

- Output Speed Sensor (OSS) Circuit Low Voltage

DTC P0723

- Output Speed Sensor (OSS) Intermittent

Diagnostic Fault Information

Typical Scan Tool Data