2010 Cadillac CTS Sedan AWD V6-3.6L Page 400
DTC B1517
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1517 03
- Battery Voltage Below Threshold
DTC B1517 07
- Battery Voltage Above Threshold
DTC B1517 5A
- Battery Voltage Plausibility Failure
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) has designated circuits for monitoring vehicle system voltage. The BCM monitors the system voltage to ensure
that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the system voltage is out of range. The
BCM monitors the system voltage over an extended length of time. If the BCM detects the system voltage is outside an expected range for the
calibrated length of time, or the 2 BCM battery sense circuits differ by 2 V, DTC B1517 A will set.
Conditions for Running the DTC
* The BCM has power and ground.
* The ignition is not in the START position.
Conditions for Setting the DTC
B1517 03
* The battery voltage is less than 11 V.
* The engine speed is greater than 1,100 RPM.
* The above conditions are met for 15 seconds.
B1517 07
* The battery voltage is greater than 16 V.
* The engine speed is greater than 1,100 RPM.
* The above conditions are met for 15 seconds.
B1517 5A
The battery voltage differs by 2 V on the BCM battery sense circuits for 10 seconds.
Action Taken When the DTC Sets
* The instrument panel cluster (IPC) illuminates the charge indicator.
* The driver information center (DIC) displays the SERVICE BATTERY CHARGING SYSTEM warning message.
Conditions for Clearing the DTC
* The DTC will clear current status when fault is no longer present.
* The history DTC will clear after 50 consecutive ignition cycles have occurred without a malfunction.
No comments:
Post a Comment