2010 Cadillac CTS Sedan AWD V6-3.6L Page 410

2010 Cadillac CTS Sedan AWD V6-3.6L Page 410

Conditions for Clearing the DTC

* A current DTC will clear when the fault is no longer present.

* A history DTC will clear after 40 malfunction-free ignition cycles.

Reference Information

Schematic Reference

Outside Rearview Mirror Schematics (See: Body and Frame/Mirrors/Diagrams/Electrical Diagrams/Outside Rearview Mirror Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Outside Mirror Description and Operation (See: Body and Frame/Mirrors/Description and Operation/Outside Mirror Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Command the left and right outside mirror to move up, down, left and right using the mirror directional switch. The mirror should move in the

commanded direction.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the appropriate outside rearview mirror.

2. Connect a test lamp between the control circuit terminal 3 and the control circuit terminal 2.

3. Ignition ON, command the mirror LEFT and RIGHT with a scan tool. The test lamp should turn ON when commanding the LEFT and

RIGHT states.

瀚慖f the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground or an open/high resistance on

either control circuits. If the circuits test normal, replace the appropriate door module.

4. Connect a test lamp between the control circuit terminal 1 and the control circuit terminal 2.

5. Ignition ON, command the mirror UP and DOWN with a scan tool. The test lamp should turn ON when commanding the UP and DOWN

states.

瀚慖f the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground or an open/high resistance on

either control circuits. If the circuits test normal, replace the door module.

6. If all circuits test normal, test or replace the outside rearview mirror motor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Outside Rearview Mirror Motor Replacement (See: Body and Frame/Mirrors/Power Mirror Motor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for DDM and PDM replacement, setup, and

programming

B1580

DTC B1580 or B1590

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an