Friday, November 6, 2020

2010 Cadillac CTS Sedan AWD V6-3.6L Page 137

2010 Cadillac CTS Sedan AWD V6-3.6L Page 137



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.



Circuit/System Verification



Important: The seat belt pretensioners may deploy for impacts that are not severe enough to warrant frontal or side air bag deployment.



The SDM is capable of sustaining 3 pretensioner deployment events, or one frontal or side deployment event. After the maximum number



of deployments has occurred, DTC B0052 sets and becomes a latched code, which cannot be cleared.



1. Verify DTC B0055 is not set.



瀚慖f DTC B0055 is set, replace SDM.



2. Verify DTC B0052 is not set.



瀚慖f DTC B0052 is set, clear the DTC and operate the vehicle within the conditions for running the DTC. If the DTC resets, replace the



SDM.



3. Verify DTC B0053 is not set.



瀚慖f DTC is set along with additional DTCs, repair the malfunction causing the DTCs before replacing the SDM.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming



B0055



DTC B0052, B0053, or B0055



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC B0052 00



- Deployment Commanded



DTC B0053 00



- Deployment Commanded With Loop DTCs Present



DTC B0055 00



- Side Airbag Deployment Commanded



Circuit/System Description



The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity changes into an electrical



signal. The SDM compares this electrical signal to a value stored in memory. When the generated signal exceeds the stored value, the SDM



performs additional signal processing and compares the generated signals to values stored in memory. When 2 of the generated signals exceed the



stored values, the SDM will cause current to flow through the appropriate deployment loops.



Conditions for Running the DTC



Ignition voltage is between 9-16 volts.



Conditions for Setting the DTC

No comments:

Post a Comment