2010 Cadillac CTS Sedan AWD V6-3.6L Page 287

2010 Cadillac CTS Sedan AWD V6-3.6L Page 287

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

* The VIN check flag of the RCDLR is true.

* The RCDLR has determined that the battery has been reconnected after a battery disconnect.

Action Taken When the DTC Sets

* The vehicle will not start.

* The RCDLR sends the fuel disable message via the serial data circuit to the ECM.

* The RCDLR sends a message to the IPC to illuminate the SECURITY indicator.

Conditions for Clearing the DTC

The RCDLR clears the current DTC when the correct VIN information is present.

Reference Information

Schematic Reference

Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Immobilizer Description and Operation (without Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

Operation/Immobilizer Description and Operation (Without Y41))Immobilizer Description and Operation (with Y41) (See: Accessories and

Optional Equipment/Antitheft and Alarm Systems/Description and Operation/Immobilizer Description and Operation (With Y41))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

With a scan tool, verify DTC B1016 is not set.

If DTC is set, program the RCDLR. If DTC resets, replace the RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for RCDLR replacement, setup, and programming

Without Y41

DTC B1016 (without Y41)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.