Friday, October 30, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1580

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1580



* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/Electronic Component Description)



* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/Transmission General Description)



* Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/Transmission Component and System Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Circuit/System Verification



1. Engine idling at normal operating temperature, verify the scan tool TCM Temperature parameter is between -247 and +247掳C (-412 and



+477掳F).



瀚慖f not within the specified range, replace the Q8 control solenoid valve assembly.



2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature parameter and the Transmission Fluid Temperature



parameter with a scan tool. The TCM Temperature parameter should increase by more than 2掳C (3.5掳F). Also, the TCM Temperature



parameter and the Transmission Fluid Temperature parameter should be within 10掳C (18掳F) of each other.



瀚慖f the TCM Temperature parameter does not increase by more than 2掳C (3.5掳F) or the TCM Temperature parameter value is not within 10



掳C (18掳F) of the Transmission Fluid Temperature parameter, then replace the Q8 control solenoid valve assembly.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Control solenoid valve assembly replacement. Refer to Control Module References (See: Testing and Inspection/Programming and



Relearning) for replacement, setup, and programming.



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.



P0685, P0686, P0687, P0689, or P0690



DTC P0685, P0686, P0687, P0689, or P0690



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0685



- Engine Controls Ignition Relay Control Circuit



DTC P0686



- Engine Controls Ignition Relay Control Circuit Low Voltage



DTC P0687



- Engine Controls Ignition Relay Control Circuit High Voltage



DTC P0689



- Engine Controls Ignition Relay Feedback Circuit Low Voltage



DTC P0690



- Engine Controls Ignition Relay Feedback Circuit High Voltage



Diagnostic Fault Information

No comments:

Post a Comment