Thursday, September 24, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1491

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1491



If the DTC is set, program the K27 fuel pump control module.



Verify that DTCs P0601, P0603, P0604, P0606, and P062F are not set.



If the DTCs are set, program the K27 fuel pump control module. If the DTCs reset, replace the K27 fuel pump control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for fuel pump control module replacement, setup, and



programming



P0601-P0604 or P062F



DTC P0601-P0604 or P062F



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



Note: DTCs P0601, P0602, P0603, P0604 or P062F could set in other control modules. Verify the DTCs are set in the transmission control module



(TCM).



DTC P0601



- Control Module Read Only Memory (ROM)



DTC P0602



- Control Module Not Programmed



DTC P0603



- Control Module Long Term Memory Reset



DTC P0604



- Control Module Random Access Memory (RAM)



DTC P062F



- Control Module Long Term Memory Performance



Circuit/System Description



This is an internal fault detection of the control solenoid valve assembly. This fault is carried out inside the control solenoid valve assembly and no



external circuits are involved.



Conditions for Running the DTC



* DTCs P0601, P0602, P0603, P0604, or P062F are not set.



* Ignition voltage is 8.6 volts or greater.



Conditions for Setting the DTC



P0601



The read only memory (ROM) test has failed 5 or more times.



P0602



The transmission control module (TCM) has not been programmed.

No comments:

Post a Comment