Friday, September 18, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1662

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1662



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector of the CPP sensor.



2. Ignition ON, observe the scan tool CPP sensor voltage parameter for 0.1-volt.



瀚慖f the voltage is below the specified value, replace the CPP sensor.



瀚慖f the voltage is above the specified value, replace the ECM.



Component Testing



1. Ignition OFF, disconnect the harness connector of the CPP sensor.



2. Measure the resistance between the signal terminal B and the low reference terminal A of the CPP sensor. Sweep the CPP sensor through the



entire range. The resistance should vary low to high and high to low without any spikes or dropouts.



瀚慖f the resistance is erratic with spikes or dropouts, replace the CPP sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Clutch Pedal Replacement (See: Transmission and Drivetrain/Clutch/Clutch Pedal Assembly/Service and Repair/Clutch Pedal Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup and programming



Aisin AY6 - Manual Transmission



DTC P0807 or P0808



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0807



- Clutch Pedal Position (CPP) Sensor Circuit Low Voltage



DTC P0808



- Clutch Pedal Position (CPP) Sensor Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Information

No comments:

Post a Comment