Wednesday, September 16, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1759

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1759



Conditions for Setting the DTC



The fuel pump control module detects an over-temperature fault.



Action Taken When the DTC Sets



DTCs P064A and P1255 are Type A DTCs.



Conditions for Clearing the DTC



DTCs P064A and P1255 are Type A DTCs.



Diagnostic Aids



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records



can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the



diagnostic test reported a pass and/or a fail.



Reference Information



Schematic Reference



Engine Controls Schematics (LLT) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Fuel System Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Fuel System Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Testing



1. Verify that DTC P0231, P0232 or P023F are not set.



瀚慖f any of those codes are set, refer to DTC P0231, P0232, or P023F (See: P Code Charts/P0231).



2. Ensure that the entire undercarriage of the vehicle is clean, especially around the area where the K27 fuel pump control module is located.



Clear all codes from the K27 fuel pump control module and test drive the vehicle. Verify that DTC P1255 or P064A do not set.



瀚慖f DTC P1255 or P064A reset, replace the K27 fuel pump control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning)for fuel pump control module replacement, setup, and



programming



P1258



DTC P1258



Diagnostic Instructions

No comments:

Post a Comment