Thursday, September 17, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1640

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1640



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Replace the control solenoid valve assembly. Refer to Control Module References (See: Testing and Inspection/Programming and



Relearning) for replacement, setup, or programming.



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.



P0756



DTC P0756



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0756



- Shift Solenoid (SS) 2 Valve Performance - Stuck Off



Circuit/System Description



The shift solenoid (SS) 2 is part of the control solenoid valve assembly which has no serviceable parts. The control solenoid valve assembly is



attached to the lower control valve body. The solenoid operates by the TCM opening or closing the ground circuit. With the solenoid circuit



grounded (solenoid on), the internal plunger and metering ball block the exhaust fluid creating signal fluid pressure. The signal fluid acts against



the clutch select valve 3 to overcome the valve spring force moving it to the apply position, allowing the shift. The TCM shifts the transmission by



operating the solenoids in on/off combinations.



Conditions for Running the DTC



* DTCs P0121, P0122, P0123, P0716, P0717, P0722, P0723, or P182E are not set.



* Ignition voltage is 8.6 volts or greater.



* The engine speed is greater than 500 RPM.



* The engine run time is greater than 5 seconds.



* High Side Driver (HSD) 1 is enabled.



* Accelerator pedal position signal is valid



* The TCM must receive a valid torque signal from the ECM.



* Throttle position is 0.5 percent or greater.



* Transmission fluid temperature (TFT) is 0掳C (32掳F) or greater.



Conditions for Setting the DTC



* Commanded gear is 1st locked.



* Transmission gearbox slip is 200 RPM for 10 seconds.



* Transmission forces 2nd gear.



* Transmission has obtained a valid 2nd for 3 seconds.



Action Taken When the DTC Sets

No comments:

Post a Comment