Monday, September 14, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1996

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1996



* Pressure Control Solenoid Valve 4 Performance Test Status



* Pressure Control Solenoid Valve 4 Control Circuit High Voltage Test Status



* Pressure Control Solenoid Valve 4 Control Circuit Low Voltage Test Status



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



Note: You must perform the Circuit/System Verification first.



1. Ignition OFF, remove the Q8 control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly



Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids - Transmission and



Drivetrain/Actuators and Solenoids - A/T/Shift Solenoid/Service and Repair).



2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/Control Solenoid Valve and Transmission Control



Module Assembly Inspection).



3. Place the Q8 control solenoid valve assembly on a clean work surface near the transmission assembly.



4. Connect DT-47825-10 - jumper harness between the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly



electrical connector.



5. Ignition ON, verify with a scan tool the following test status parameters display OK:



* Pressure Control Solenoid Valve 4 Performance Test Status



* Pressure Control Solenoid Valve 4 Control Circuit High Voltage Test Status



* Pressure Control Solenoid Valve 4 Control Circuit Low Voltage Test Status



瀚慖f any test status parameter displays Fault or Malfunction, replace the Q8 control solenoid valve assembly.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.



* Replace the control solenoid valve assembly. Refer to Control Module References (See: Testing and Inspection/Programming and



Relearning) for replacement, setup, and programming.



P2720



DTC P2719-P2721



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P2719



- Clutch Pressure Control (PC) Solenoid 4 System Performance



DTC P2720



- Clutch Pressure Control (PC) Solenoid 4 Control Circuit Low Voltage



DTC P2721



- Clutch Pressure Control (PC) Solenoid 4 Control Circuit High Voltage



Diagnostic Fault Information



Typical Scan Tool Data

No comments:

Post a Comment