2010 Cadillac CTS Sedan AWD V6-3.0L Page 1924

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1924

DTC P2230

- Barometric Pressure (BARO) Sensor Circuit Erratic

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The barometric pressure (BARO) sensor responds to changes in altitude and atmospheric conditions. This gives the engine control module (ECM)

an indication of barometric pressure. The ECM uses this information to calculate fuel delivery. The BARO sensor provides a voltage signal to the

ECM relative to the atmospheric pressure changes. The ECM monitors the BARO sensor signal for a voltage outside of the normal range.

Conditions for Running the DTC

P2227

* DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0222, P0223, P1516,

P2135, P2228 and P2229 are not set.

* Engine is running.

OR

* DTCs P0106, P0107, P0108, P2228, P2229 and P2230 are not set and are not pending.

* Ignition ON, engine OFF.

* DTC P2227 runs continuously when the above conditions are met.

P2228 or P2229

* The engine is running.

* The DTCs run continuously when the above condition is met.

P2230

* The engine is running.

* DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0222, P0223, P1516,

P2135, P2228 and P2229 are not set.

* DTC P2230 runs continuously when the above conditions are met.

Conditions for Setting the DTC

P2227

* Engine running, the ECM detects that the difference between the BARO signal and the calculated BARO is greater than 15 kPa (2.2 psi)

when the vehicle has traveled no more than 0.5 km (0.31 mi) since the last calculated BARO update, or if the difference is greater than 25

kPa (3.6 psi) when the vehicle has traveled greater than 0.5 km (0.31 mi) since the last calculated BARO update.

* Ignition ON, engine OFF, the ECM detects that the BARO pressure is less than 50 kPa (7.3 psi) or greater than 115 kPa (16.7 psi).

P2228

The ECM detects that the BARO sensor voltage is less than 1.95 V for greater than 4 s.

P2229

The ECM detects that the BARO sensor voltage is greater than 4.5 V for greater than 4 s.

P2230

The ECM detects that the difference between the current BARO sensor reading and the previous BARO sensor reading is greater than 10 kPa (1.5