Saturday, July 18, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1540

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1540



Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



P0634



DTC P0634



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0634



- Transmission Control Module (TCM) Overtemperature



Circuit/System Description



The transmission control module (TCM) temperature sensor is located inside of the control solenoid valve assembly which has no serviceable parts.



The TCM monitors the TCM sensor for over temperature protection.



Conditions for Running the DTC



* Ignition voltage is between 8.6 volts or greater.



* The TCM temperature is between 0掳C (32掳F) and 170掳C (338掳F) for 0.25 seconds.



* DTC P0634 and has not set this ignition.



Conditions for Setting the DTC



Condition 1



The TCM has detected an internal temperature condition greater than 142掳C (288掳F) for 5 seconds.



Condition 2



Ignition voltage is equal to or greater than 18 volts and the TCM temperature is greater than 50掳C (122掳F) for 2 seconds.



Action Taken When the DTC Sets



* DTC P0634 is a Type A DTC.



* The TCM shifts to a default gear, shuts down, and turns OFF.



* The TCM disables TAP shift operation.



* The TCM enables torque management.



Conditions for Clearing the DTC



DTC P0634 is a Type A DTC.



Diagnostic Aids



During a road test, the TCM temperature should steadily increase to a normal operating temperature, then stabilize.



Reference Information



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/Electronic



Component Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Circuit/System Verification

No comments:

Post a Comment