2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 3002
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* GMLAN Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Wiring Repairs/GMLAN Wiring Repairs)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for control module replacement, setup, and
programming
U0073
DTC U0073 or U2100
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC U0073 00
- Control Module Communication Bus Off
DTC U0073 71
- ECU HS Bus Off
DTC U0073 72
- ECU LS Bus Off
DTC U2100 00
- Controller Area Network (CAN) Bus Communication
DTC U2100 47
- Controller Area Network (CAN) Bus Communication
Circuit/System Description
The serial data circuits are serial data buses are used to communicate information between the control modules. The serial data circuits also connect
directly to the data link connector (DLC).
Conditions for Running the DTCs
No comments:
Post a Comment