2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 611

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 611

test normal, replace the seat back heater element/temperature sensor.

3. Connect the X2, X5 harness connectors at the MSM.

4. Disconnect the harness connector at the seat back heater element/temperature sensor.

5. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the MSM.

瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the MSM.

6. If all circuits test normal, replace the MSM.

B2440 02 or B2440 05

1. Ignition OFF, disconnect the X2, X5 harness connectors at the MSM.

2. Test for 850 Ohms - 300 kOhms between the signal circuit terminal 3 X5 and the low reference circuit terminal 5 X2.

瀚慖f less than the specified range, test for a short between the signal and low reference circuits. If the circuits test normal, replace the seat

back heater element/temperature sensor.

瀚慖f greater than the specified range, test the signal and low reference circuits for a short to voltage or an open/high resistance. If the circuits

test normal, replace the seat back heater element/temperature sensor.

3. Connect the X2, X5 harness connectors at the MSM.

4. Disconnect the harness connector at the seat back heater element/temperature sensor.

5. Ignition ON, test for 4.8 - 5.2 V between the signal circuit terminal C and ground.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the MSM.

瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the MSM.

6. If all circuits test normal, replace the MSM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Driver or Passenger Seat Back Cushion Heater Replacement (Escalade with HP2) ()Driver or Passenger Seat Back Cushion Heater

Replacement (Tahoe with HP2) ()Driver or Passenger Seat Back Cushion Heater Replacement (without HP2) ()

* Control Module References (See: Testing and Inspection/Programming and Relearning) for the MSM replacement, setup, and programming

HP2 or Dealer Installed W/O Memory

DTC B2435 or B2440 (HP2 or Dealer Installed w/o Memory)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B2435 02

- Left Seat Back Heater Sensor Circuit Short to Ground

DTC B2435 05

- Left Seat Back Heater Sensor Circuit Short to Battery or Open

DTC B2440 02

- Right Seat Back Heater Sensor Circuit Short to Ground

DTC B2440 05

- Right Seat Back Heater Sensor Circuit Short to Battery or Open

Diagnostic Fault Information