Monday, February 25, 2019

Disclaimer2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00261 Date: 100219

Disclaimer2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00261 Date: 100219



Lighting - Condensation/Misting Inside Rear Lamps



No.: LTB00261



Issue: 1



Date: 19 FEB 2010



SECTION: 417



Rear Lamp Condensation / Misting



AFFECTED VEHICLE RANGE:



CONDITION SUMMARY:



Situation:



Condensation or misting may be evident in the rear lamp assemblies. This may be caused by moisture inside the lamp lenses.



Action:



In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install vents in the rear lamp assemblies.



2010 Land Rover LR2 (LF) L6-3.2L Page 71



PARTS:



TOOLS:



Refer to Workshop Manual (GTR) for any required special tools



WARRANTY:



NOTE:



Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.



Always refer to DDW to obtain the latest repair time.



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



Normal warranty policy and procedures apply.



REPAIR PROCEDURE



INSTALL VENTS TO REAR LAMP ASSEMBLIES



NOTE:



Global Technical Reference (GTR) lookup sequence is as follows:



GTR Home > NAS > LF - LR2 > Service Information> Model Year > Workshop Manual



1. Refer to Workshop Manual (GTR) section 417-01, Exterior Lighting, and remove the left rear lamp assembly.



2. Remove the plastic nitto vent. (Figure 1)



2010 Land Rover LR2 (LF) L6-3.2L Page 72



3. Install the new vent tube to the lamp assembly. (Figure 2)



4. Refer to Workshop Manual (GTR) section 417-01, Exterior Lighting, and install the left rear lamp assembly.



5. Repeat steps 1 - 4 on the right rear lamp assembly.

No comments:

Post a Comment