Thursday, July 21, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 812

2010 Cadillac Truck SRX FWD V6-3.0L Page 812



2. Command the Parking Brake Cable Service Release to Released with a scan tool. The BRAKE light should turn off and the Park Brake



Status on the scan tool should display Released.



瀚慖f the BRAKE light does not turn off or the Park Brake Status does not display Released replace the K83 Parking Brake Control Module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for parking brake control module replacement, setup, and



programming



C0299



DTC C0299



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC C0299 5A



- Brake Booster Large Vacuum Leak Detected Not Plausible



Diagnostic Fault Information



Circuit/System Description



The brake booster vacuum sensor measures the vacuum in the brake booster assembly. The electronic brake control module (EBCM) supplies a 5 V



reference and a low reference circuit to the brake booster vacuum sensor. The vacuum sensor supplies a voltage signal in relation to the pressure in



the brake booster to the EBCM.



Conditions for Running the DTC



Ignition ON.



Conditions for Setting the DTC



The EBCM detected a too low vacuum in the brake booster assembly for 120 seconds.



Action Taken When the DTC Sets



The brake warning indicator turns ON.



Conditions for Clearing the DTC



* A current DTC clears when the diagnostic runs and passes.



* The EBCM will turn OFF the indicator in the next ignition cycle.



Reference Information



Schematic Reference



Hydraulic Brake Schematics (See: Brakes and Traction Control/Hydraulic System/Diagrams/Electrical Diagrams)

No comments:

Post a Comment