Friday, July 22, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 807

2010 Cadillac Truck SRX FWD V6-3.0L Page 807



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provide an overview of each diagnostic category.



DTC Descriptors



DTC C0293 01



- Park Brake Switch Control Short to Battery



DTC C0293 06



- Park Brake Switch Control Low Voltage/Open



DTC C0293 08



- Park Brake Switch Control Performance-Signal Invalid



Circuit/System Description



The electric parking brake control module has an internal motor, apply actuator, release actuator, and temperature sensor. The electric parking brake



control module also contains the logic for applying and releasing the parking brake when commanded by the electric parking brake switch. The



electric parking brake module will perform diagnostics on the electric parking brake switch and its wiring harness to verify it is functioning



properly. When the electric parking brake control module receives a signal from the switch the internal circuit board temperature is checked to



verify it is within operating range before the control module performs the requested operation.



The electric park brake switch control diagnostic checks for failure conditions in the electric park brake switch and associated wiring into the



electric park brake module.



Conditions for Running the DTC



Ignition OFF, ACCESSORY, or RUN mode.



Conditions for Setting the DTC



The electric parking brake module detects a short to battery, short to ground, open circuit, or an internal parking brake switch control malfunction.



Action Taken When the DTC Sets



* The electric parking brake is disabled.



* A DIC message and/or a warning indicator may be displayed.



Conditions for Clearing the DTC



* The electric parking brake module clears the history DTC when a current DTC is not detected in 40 ignition cycles.



* The condition for the DTC is no longer present.



Reference Information



Schematic Reference



Park Brake System Schematics (See: Brakes and Traction Control/Parking Brake System/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Electronic Parking Brake Control Module Description (See: Brakes and Traction Control/Parking Brake System/Parking Brake Control



Module/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)

No comments:

Post a Comment