Thursday, June 9, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1093

2010 Cadillac Truck SRX FWD V6-3.0L Page 1093



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Testing



1. Verify that DTC P0231, P0232 or P023F are not set.



瀚慖f any of those codes are set, refer to DTC P0231, P0232, or P023F (See: P Code Charts/P0231).



2. Ensure that the entire undercarriage of the vehicle is clean, especially around the area where the K27 fuel pump control module is located.



Clear all codes from the K27 fuel pump control module and test drive the vehicle. Verify that DTC P1255 or P064A do not set.



瀚慖f DTC P1255 or P064A reset, replace the K27 fuel pump control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for fuel pump control module replacement, setup, and



programming



P0068



DTC P0068 or P1101



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0068



- Throttle Body Airflow Performance



DTC P1101



- Intake Air Flow System Performance



Circuit/System Description



The engine control module (ECM) compares actual airflow based on throttle position (TP) to a calculated airflow based on manifold absolute



pressure (MAP) sensor, and mass air flow (MAF).



Conditions for Running the DTC



DTC P0068



* The engine speed is greater than 800 RPM.



* The ignition voltage is greater than 6.0 V.



* The throttle actuator control system is not in reduced power mode.



* The DTC runs continuously when the above conditions are met.



DTC P1101



* DTCs P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0335, P0336 are not set



* The engine speed is between 400-7,000 RPM



* The engine coolant temperature (ECT) is between 69-127掳C (156-260掳F).



* The intake air temperature (IAT) is between -20 to +125掳C (-4 to +257掳F).



* The DTC runs continuously when the above conditions are met.



Conditions for Setting the DTC



The ECM detects that the actual airflow rate is greater than the calculated airflow.



Action Taken When the DTC Sets



* DTC P0068 is a type A DTC.

No comments:

Post a Comment