Saturday, June 18, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 856

2010 Cadillac Truck SRX FWD V6-3.0L Page 856



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



Ignition ON, observe the scan tool Vertical Wheel Acceleration parameters. The parameters should be 0 m/s(2) when the vehicle is parked on a



level surface.



Circuit/System Testing



1. Ignition ON, verify that DTC C0870 is not present.



瀚慖f the DTC is present, refer to DTC C0870 (See: C Code Charts/C0870) to diagnose that DTC prior to this diagnostic.



2. Ignition OFF, disconnect the harness connector at the appropriate B161 vertical suspension acceleration sensor.



3. Ignition OFF, open/close doors, and wait 60 seconds. Test for less than 5 ohm between the low reference circuit terminal C and ground.



瀚慖f greater than the specified value, test the low reference circuit for short to voltage or an open/high resistance. If the circuit tests normal,



replace the K19 Suspension Control Module.



4. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal A and ground.



瀚慖f less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal,



replace the K19 suspension control module.



瀚慖f greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K19



suspension control module.



5. Test for 4.8-5.2 V between the signal circuit terminal B and ground.



瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace



the K19 suspension control module.



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K19 suspension



control module.



6. If all circuits test normal, replace the B161 vertical suspension acceleration sensor. Verify the DTC does not reset. If the DTC resets, replace



the K19 suspension control module



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Electronic Suspension Front Vertical Accelerometer Replacement - Lower (See: Sensors and Switches/Sensors and Switches - Steering and



Suspension/Sensors and Switches - Suspension/Acceleration Sensor/Service and Repair/Electronic Suspension Front Vertical Accelerometer



Replacement - Lower)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for suspension control module replacement, setup



and programming



C0675



DTC C0670 or C0675



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC C0670 02



- Left Front Acceleration or Position Sensor Circuit Short to Ground

No comments:

Post a Comment