Thursday, May 5, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 1864

2010 Cadillac Truck SRX FWD V6-3.0L Page 1864



瀚慖f any TFP Switch parameter does not change states, replace the control solenoid valve assembly.



Repair Instructions



Note:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs.



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission



and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic



Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup, or



programming



P1101



DTC P0068 or P1101



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0068



- Throttle Body Airflow Performance



DTC P1101



- Intake Air Flow System Performance



Circuit/System Description



The engine control module (ECM) compares actual airflow based on throttle position (TP) to a calculated airflow based on manifold absolute



pressure (MAP) sensor, and mass air flow (MAF).



Conditions for Running the DTC



DTC P0068



* The engine speed is greater than 800 RPM.



* The ignition voltage is greater than 6.0 V.



* The throttle actuator control system is not in reduced power mode.



* The DTC runs continuously when the above conditions are met.



DTC P1101



* DTCs P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0335, P0336 are not set



* The engine speed is between 400-7,000 RPM



* The engine coolant temperature (ECT) is between 69-127掳C (156-260掳F).



* The intake air temperature (IAT) is between -20 to +125掳C (-4 to +257掳F).



* The DTC runs continuously when the above conditions are met.



Conditions for Setting the DTC



The ECM detects that the actual airflow rate is greater than the calculated airflow.



Action Taken When the DTC Sets



* DTC P0068 is a type A DTC.



* DTC P1101 is a type B DTC.



Conditions for Clearing the DTC

No comments:

Post a Comment