2010 Cadillac Truck SRX FWD V6-3.0L Page 1671

2010 Cadillac Truck SRX FWD V6-3.0L Page 1671

* TCM-Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for replacement, setup, and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

6T70/6T75 - Automatic Transmission

DTC P0711, P0712, or P0713

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0711

- Transmission Fluid Temperature (TFT) Sensor Performance

DTC P0712

- Transmission Fluid Temperature (TFT) Sensor Circuit Low Voltage

DTC P0713

- Transmission Fluid Temperature (TFT) Sensor Circuit High Voltage

Circuit/System Description

The transmission fluid temperature (TFT) sensor is located inside of the transmission control module (TCM) assembly which has no serviceable

components. The TFT sensor provides transmission fluid temperature to the TCM. This fault is handled inside the TCM and no external circuits are

involved.

Conditions for Running the DTC

P0711

* No DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207,

P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0658, P0668, P0669, P06AD, P06AE, P0711,

P0712, P0713, P0716, P0717, P0722, P0723, P0962, P0963, P0966, P0967, P0970, P0971, P215C, P2720, P2721, P2729, or P2730.

* The engine speed is greater than 400 RPM for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

* Brake torque is not active.

* The engine torque signal is valid.

* The throttle position signal is valid.

P0712

* No DTCs P0712, P0716, P0717, P0722, or P0723.

* The engine speed is greater than 400 RPM for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

P0713

* No DTCs P0713, P0716, P0717, P0722, or P0723.

* The engine speed is greater than 400 RPM for 5 seconds.

* The ignition voltage is 8.6 volts or greater.

Conditions for Setting the DTC

P0711

The difference between the transmission fluid temperature (TFT) and TCM temperature and the difference between the TFT and TCM power up

temperature are both greater than 20-50掳C (36-90掳F). The temperature threshold is dependent on the average temperature of the TFT, TCM

temperature, and TCM power up temperature.

P0712

The TFT is less than -74掳C (-101掳F) for 1 minute.