2010 Cadillac Truck SRX FWD V6-3.0L Page 1767
P0842 or P0843
* No DTCs P0711, P0712, P0713, P0716, P0717, P0722, P0723, P0742, P0751, P0756, P0757, P0973, P0974, P0976, P0977, P1915, P182E.
* The high side driver is on.
* The engine speed is 400 RPM or greater for 5 seconds.
* The engine speed is 550 RPM or greater.
* Ignition voltage is 8.6 volts or greater.
* The transmission fluid temperature (TFT) is 0-120掳C (32-248掳F).
Conditions for Setting the DTC
P0842
The TCM detects that the TFP switch 1 signal voltage remains LOW after the 3-5-R clutch transitions from a HIGH pressure state to a LOW
pressure state. The TCM counts each incident. The DTC sets when 25 counts are accumulated.
P0843
The TCM detects that the TFP switch 1 signal voltage remains HIGH after the 3-5-R clutch transitions from a LOW pressure state to a HIGH
pressure state. The TCM counts each incident. The DTC sets when 35 counts are accumulated.
Action Taken When the DTC Sets
* DTCs P0842 and P0843 are Type C DTCs.
* The TCM freezes transmission adaptive functions for the 35R clutch.
Conditions for Clearing the DTC
DTCs P0842 and P0843 are Type C DTCs.
Diagnostic Aids
A TFP switch may malfunction due to normal debris in the transmission fluid causing a TFP Switch DTC to intermittently set. This type of failure
should not be immediately noticeable to a customer, as the switch outputs are used for shift adaptives and do not cause transmission symptoms
unless the switch malfunctions continuously for an extended period of time.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)
Connector End View Reference
* Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
* Inline Harness Connector End Views (See: Diagrams/Connector Views/Multiple Junction Connector/Connector End Views By Number)
Description and Operation
* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6T70/6T75 - Automatic Transmission/Transmission General Description)
* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6T70/6T75 - Automatic Transmission/Electronic Component Description) for control solenoid valve assembly
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
No comments:
Post a Comment