2010 Cadillac Truck SRX FWD V6-3.0L Page 1600

2010 Cadillac Truck SRX FWD V6-3.0L Page 1600

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Engine running. Let the engine run for at least 1 min.

2. Ignition OFF for at least 30 s to allow for the complete shutdown of the TCM.

3. Ignition ON, verify that DTC P0602 is not set.

瀚慖f the DTC is set, program the TCM. If the DTC resets, replace the TCM.

4. Observe the DTC information with a scan tool. DTCs P0601, P0603, P0604 should not set.

瀚慖f a DTC sets, replace the TCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for TCM replacement, setup, and

programming.

* Perform the Transmission Adaptive Functions (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/AF40-6 - Automatic Transmission/Transmission Adaptive Functions).

Fuel Pump Control Module

DTC P0601-P0604, P0606, or P062F (Fuel Pump Control Module)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0601

- Control Module Read Only Memory (ROM)

DTC P0602

- Control Module Not Programmed

DTC P0603

- Control Module Long Term Memory Reset

DTC P0604

- Control Module Random Access Memory (RAM)

DTC P0606

- Control Module Internal Performance

DTC P062F

- Control Module Long Term Memory Performance

Circuit/System Description

The internal fault detection is handled inside the fuel pump control module. No external circuits are involved.

Conditions for Running the DTC

The fuel pump control module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and

ground. This program runs even if the voltage is out of the valid operating range.

Conditions for Setting the DTC

The fuel pump control module has detected an internal malfunction.