Friday, April 15, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 871

2010 Cadillac Truck SRX FWD V6-3.0L Page 871



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Special Tools



J-46079 Tire Pressure Monitor Diagnostic Tool



Circuit/System Verification



1. Using the J-46079 , activate each tire pressure sensor and record each sensors transmission data and physical location. Verify J-46079



displays the 8-digit ID number, accurate tire pressure +/- 27.6 kPa (4 psi), Learn Mode, and at least a 1/4 graph signal strength displayed.



瀚慖f any of the parameters listed above are not displayed, replace the suspect tire pressure sensor.



2. With the scan tool, verify tire pressure sensors ID and locations displayed on the scan tool match the IDs and locations recorded from the



special tool.



瀚慖f the IDs and locations do not match, perform the Tire Pressure Indicator Sensor Learn (See: Instrument Panel, Gauges and Warning



Indicators/Tire Monitoring System/Tire Pressure Sensor/Testing and Inspection).



3. Enable the TPM learn mode. Use the J-46079 in simulate mode to learn 4 simulated sensor transmissions into the BCM. Verify that all 4



simulated sensor locations, IDs, and tire pressures displayed on the TPM special tool match the corresponding scan tool parameters



displayed.



瀚慖f the scan tool does not match, replace the K9 BCM.



4. Test drive the vehicle above 40 km/h (25 mph) for greater than 2 minutes. With the scan tool, observe the suspect Pressure Sensor Mode data



parameter. Verify the sensor mode changes to Rolling.



瀚慖f the Pressure Sensor Mode does not change, replace the suspect tire pressure sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Tire Pressure Indicator Sensor Replacement (See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure



Sensor/Service and Repair)



* Tire Pressure Indicator Sensor Learn (See: Instrument Panel, Gauges and Warning Indicators/Tire Monitoring System/Tire Pressure



Sensor/Testing and Inspection)



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup and programming.



C0775



DTC C0775



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC C0775 00



- Low Tire Pressure System Sensors Malfunction



Circuit/System Description



If the tire pressure sensor learn procedure has not been performed, the tire pressure monitor indicator icon on the instrument panel cluster (IPC) will



flash for 1 minute and then remain illuminated after the ignition switch is cycled ON and the IPC bulb check is complete. If equipped, the driver



information center (DIC) will also display a service tire monitor type message. Under these circumstances, DTC C0775 will be set and the tire



pressure sensor learn procedure will need to be performed for the system to function correctly.



Conditions for Running the DTC

No comments:

Post a Comment