2010 Cadillac Truck SRX FWD V6-3.0L Page 1762

2010 Cadillac Truck SRX FWD V6-3.0L Page 1762

Inspection/Programming and Relearning) following all transmission related repairs.

* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:

Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General

Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection)

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for body control module (BCM) or control solenoid

valve assembly replacement, setup and programming

* Transmission Control Replacement (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and

Repair/6T70/6T75 - Automatic Transmission/Transmission Control Replacement)

P0817

DTC P0817

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC P0817

- Brake Transmission Shift Interlock Solenoid Actuator

Diagnostic Fault Information

Circuit/System Description

The transmission range switch is an integral part of the transmission control module (TCM). As the gear range selector lever is moved, the state of

the starter inhibit circuit may change, causing the circuit to open or close. An open circuit indicates a drive range and a low voltage signal, 0 V, at

the body control module (BCM). A closed circuit indicates PARK or NEUTRAL and a high voltage, 12 V, signal at the BCM. The BCM uses the

starter inhibit circuit status from the TCM in order to enable starter operation.

Conditions for Running the DTC

P0817

* The ignition voltage is 6.0-16.0 V.

* The transmission is not in emergency mode.

Conditions for Setting the DTC

P0817

* Start lock is output as "On" and start lock monitor signal indicates "Off" for more than 100 ms.

* After consecutive 2 times of above detection.

Action Taken When the DTC Sets

P0817

* DTCs P0817 is Type D DTC.

* No engine start possible.

Conditions for Clearing the DTC

P0817

* DTC P0817 is Type D DTC.

* Start lock is output as "On" and start lock monitor signal indicates "On" and start lock is output as "Off" and start lock monitor signal

indicates "Off" for more than 1 s.