Wednesday, February 23, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 2152

2010 Cadillac Truck SRX FWD V6-3.0L Page 2152



A certain number of no valid transmitted messages on the GMLAN serial data circuits are detected by the module.



Action Taken When the DTC Sets



* The module suspends all message transmission.



* The module uses default values for all parameters received on the GMLAN serial data circuits.



* The module inhibits the setting of all other GMLAN communication DTCs.



Conditions for Clearing the DTC



* A current DTC clears when the malfunction is no longer present.



* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.



Diagnostic Aids



* This DTC cannot be retrieved with a current status. Diagnosis of current DTC is accomplished via the symptom, Scan Tool Does Not



Communicate with GMLAN Device. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device (See: Powertrain



Management/Computers and Control Systems/Information Bus/Testing and Inspection/Symptom Related Diagnostic Procedures/Scan Tool



Does Not Communicate with High Speed GMLAN Device).



* An intermittent condition is likely to be caused by a short on the GMLAN serial data circuits. Use the Scan Tool Does Not Communicate



with GMLAN Device procedure in order to isolate an intermittent condition. Refer to Scan Tool Does Not Communicate with High Speed



GMLAN Device (See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Symptom Related



Diagnostic Procedures/Scan Tool Does Not Communicate with High Speed GMLAN Device).



Reference Information



Schematic Reference



Data Communication Schematics (See: Powertrain Management/Computers and Control Systems/Information Bus/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Data Link Communications Description and Operation (See: Powertrain Management/Computers and Control Systems/Information



Bus/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool References



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



U0002



DTC U0002



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.

No comments:

Post a Comment